airgunhunter
New member
I have an old school 4. I did a bypass with a rocker switch to have the original controller as a back up but use the Auber 99% of the time. I used it for a year with no problems and then had the heating element crack during a smoke. After that, all kinds of weird things happened. The auber got shorted a couple of times and I sent it in twice for a repair. The auber company was efficient and extremely helpful. I've been using the attached wiring diagram by CUTiger80. I have had to "re-wire" The unit about 9 times. The wire from the power cord to the heating element on the right (as you look at the cabinet from the back) is also tied to the indicator light is the one that frequently burns out/melts. I am going to try a new element. The wire to element connection on the right has melted to the connectors I have used in the past. I talked to Steve and he said my problem is probably not using high temperature wire in the right place and not using high temperature connectors. My questions for the august group are:
1) Can someone provide me with a diagram that shows exactly where the high temperature wire and connector goes? Also what is the orientation of wires connecting to the heating element? Does it matter if the power supply connects to the right or left from the back?
2) I may just skip the rocker/selector switch. I always use the Auber. Does someone have a good diagram for that?
Thank you, gentlemen! I hope you all have a blessed and Happy New Year!
Tommy in Spartanburg, SC
1) Can someone provide me with a diagram that shows exactly where the high temperature wire and connector goes? Also what is the orientation of wires connecting to the heating element? Does it matter if the power supply connects to the right or left from the back?
2) I may just skip the rocker/selector switch. I always use the Auber. Does someone have a good diagram for that?
Thank you, gentlemen! I hope you all have a blessed and Happy New Year!
Tommy in Spartanburg, SC
