Model 2D Meat probe temperature unstable.

[scubahubby]

Hi all,

Two weeks ago the temperature displayed on my 2D for the meat probe became unstable.  I used a thermapen to check the actual temperature and what was showing on the display would bounce around randomly between 15 degrees less than actual and 10 degrees more.  Last weekend it got worse and is basically useless.  Still got some great Q but had to open it up a few times and check with the thermapen.

I am assuming (since the box probe temperature is rock solid) I need a new probe.  But asking here first?  Is that what it looks like when the probe needs replacing or is this a known failure mode with the controller?

 

[old sarge]

Ozzy - It could be a number of things. The probes whether the old style or the newer style are sensitive to water. Cleaning the probe could have allowed water to enter. If that is the case, try drying it out with a hair dryer.  It that does not work, you may need a new probe. Check the controller where the jack is.  If loose, tighten it. If you take the controller off, to check for a loose wire, do so carefully. The controller (and probes) carry a 1 year warranty. Send Steve an email describing your problem.