Bella-related exterior staining

[Jim_MI]

Proud owner of a shiny new #3DW. I plan on doing a good bit of cold smoking, with my new Bella CSG. I was looking at some YouTubes about the Bellas and noticed a LOT of smoke "patina" staining on the exterior of the SI smoker they were using, all situated around and above where the  Bella smoke tube and lid vent are situated. So I am considering applying a sacrificial sheet of aluminum roof flashing to the exterior sidewall of the #3DW, just to protect the finish.

New to SI and Bella so I would really appreciate any input from Bella owners on how big of a cosmetic problem this is. And if it is a problem, are there any tried-n-true solutions yet?

TIA,  Jim

 

[old sarge]

I cannot offer any solution.  What I can say is that any surface the smoke touches will get some form of patina.  It is easily washed off.  Youre idea about a sacrificial piece of flashing should solve all or part of your concern. I might add that a lot of new users of these smokers that rely on a compression fit rather than a door seal have voice concerns over smoke seaping out of the door.  Perfectly normal. I had the same concerns.  All is well!

 

[FNH63]

I have a model 4d. I mounted my Bella on the door and had that problem too. I used a small piece of flashing just slightly wider than the bella and about 6"tall. I put it on the edge of my counter and put a slight bend on the bottom 1-1/2" and slid it behind the bella against the door. It works great at deflecting the smoke out from the door.
You are on the right track!

 

[old sarge]