Need help rewiring

[nvw-ssv]

Thanks in advance. Can someone please advise the correct wiring for Auber bypass (Analog #2) that includes the wiring from the heating element (to include white/black from incoming power cord)? I need to start from scratch in the back of my smoker and replace some wires that got a little worn. I have heat resistant wiring in 14 and 18 gauge to replace the wires that are coming off the heating element - but want to make sure I get my wiring correct the first try. The thin black wires from the red light are in tact and will not be replaced . THANKS AGAIN

I'm a little confused by the wiring diagram on SI website for Analog #2 - i had pics saved to an old laptop and it bricked on me - of when i originally did my bypass several years ago.

 

[old sarge]

These pages may be of help.

Thread 'Smokin-It Temperature Contoller Bypass'

Dec 31, 2013

Should you have a separate controller (e.g. Auber PID controller, etc) and wish to bypass the internal control, the modification is simple.

See the attached photo - it's worth a thousand words. Basically open the back of the unit, remove one layer of insulation (very itchy insulation), remove the two female quick disconnects, insert male-male jumper of your liking, wrap with electrical tape, and put everything back together again.

CAUTION: only do this if you chose to do so. Suspect take care to always use with your Auber or you may well likely burn up your unit. Also take care with...

• Paul Case Luca
• Replies: 123
• Forum: Auber Instructions

 

[nvw-ssv]

These pages may be of help.

Thread 'Smokin-It Temperature Contoller Bypass'

Dec 31, 2013

Should you have a separate controller (e.g. Auber PID controller, etc) and wish to bypass the internal control, the modification is simple.

See the attached photo - it's worth a thousand words. Basically open the back of the unit, remove one layer of insulation (very itchy insulation), remove the two female quick disconnects, insert male-male jumper of your liking, wrap with electrical tape, and put everything back together again.

CAUTION: only do this if you chose to do so. Suspect take care to always use with your Auber or you may well likely burn up your unit. Also take care with...

• Paul Case Luca
• Replies: 123
• Forum: Auber Instructions

Thanks Sarge. Got it all updated with new wiring. Your references helped very much !