scubapreacher
New member
My wall probe arrived. Next up...installing it. 1 inch from the top, centered, right?
Installing probe tonight
- Thread starter scubapreacher
- Start date
DivotMaker
New member
Perfect! Works great there, and is out of the way.
scubapreacher
New member
Probe and bypass installed. Next up, the autotune! Thanks for the help, Tony.
DivotMaker
New member
Woo Hoo! You're off and running now, Mike! Autotune's a piece of cake.
scubapreacher
New member
Autotune completed.
P 64
I 654
D 163
Sound about right?
P 64
I 654
D 163
Sound about right?
DivotMaker
New member
Sounds about right, Mike. They're all a little different. Give it a whirl on a long smoke. Mine's set to 62, 600, 120...but they can vary a bit and still work great. Once it completed the tune, did it hold the temp closely?
scubapreacher
New member
The At stopped flashing. The red indicator light was off so I assume the temp was dropping. It looked like it held close to 225 through step 2. After the At was complete, was the Auber supposed to finish the 3 steps from the program numbers 140 t.5, 225 t2.0, 140?
DivotMaker
New member
No, Mike. If the At stopped flashing, the program was done. You could have let it finish all the steps, but it's not necessary. Just wanted to see if it was holding 225 when the At stopped flashing. Sounds like you're good to go!
