Baby back, cook time
- Thread starter bogeyjim
- Start date
I have a 3-D and have filled two racks with ribs with no noticeable difference in smoke times.
Usually takes 4.5-5 hours. Have not filled all 4 racks yet but checking them at 4- 4.5 hours and then adjusting
if needed makes sense. Maybe another member can confirm their process with a full smoker of ribs.
Usually takes 4.5-5 hours. Have not filled all 4 racks yet but checking them at 4- 4.5 hours and then adjusting
if needed makes sense. Maybe another member can confirm their process with a full smoker of ribs.
barelfly
New member
I’ve filled my 3D, two full racks on each shelf, 4 total. I think they cooked same time as other smaller cooks. But, maybe add a little cushion of time just in case. Ribs are great for wrapping and holding in a cooler for a period of time if needed.
Have fun with that cook! Always fun to fill up the smoker and make full, happy bellies!
Have fun with that cook! Always fun to fill up the smoker and make full, happy bellies!
Hey Sarge,
I cut all ribs in half to fit on the shelves (3 half racks per shelf). And I alternated the pattern on the shelves every other shelf. I put the thicker ends of the ribs on the bottom two shelves. And I did not press all the ribs together, I tried to leave space for heat and smoke to circulate around the meat.
Set the smoker for 225, I'm an hour in and the interior temp. Has only reached 200 degrees (my Smoke interior temp probe is clipped to the uppermost shelf). I'd have to get real lucky to get a real time response, but for the next time.... I'm assuming the mass of meat in the smoker is preventing the heat from getting to the upper portions of the smoker?
Not sure if I should bump the heat up, as I don't want to overcook the ribs at the bottom. Check at 4 1/2 hours and pull bottom ribs if done, and leave top ribs (and lower the shelves) to make sure they're cooked?
I cut all ribs in half to fit on the shelves (3 half racks per shelf). And I alternated the pattern on the shelves every other shelf. I put the thicker ends of the ribs on the bottom two shelves. And I did not press all the ribs together, I tried to leave space for heat and smoke to circulate around the meat.
Set the smoker for 225, I'm an hour in and the interior temp. Has only reached 200 degrees (my Smoke interior temp probe is clipped to the uppermost shelf). I'd have to get real lucky to get a real time response, but for the next time.... I'm assuming the mass of meat in the smoker is preventing the heat from getting to the upper portions of the smoker?
Not sure if I should bump the heat up, as I don't want to overcook the ribs at the bottom. Check at 4 1/2 hours and pull bottom ribs if done, and leave top ribs (and lower the shelves) to make sure they're cooked?
Well, lots of worrying for nothing. Checked the ribs at 5 hours, 15 minutes, and the half racks were cracking open when grabbed with the tongs.
Only disappointment was very little bark from the Memphis Dust rub. I put it on sparingly per Meatheads suggestion, overnite in the frig. Looking for suggestions, should I have been much more liberal on the rub, or put more on just before going into the smoker?
Only disappointment was very little bark from the Memphis Dust rub. I put it on sparingly per Meatheads suggestion, overnite in the frig. Looking for suggestions, should I have been much more liberal on the rub, or put more on just before going into the smoker?
