MicKM
New member
Hello Folks, I havent been active but I am desperately in need of some same advice for Auber-Ws1200.
I have the auber unit hard installed into my smokinit #2
I live in Singapore and havent used my smoker for 6 months. I keep the auber in a zip lock bag stored inside. The permanent probe has some rust, I have cleaned and sprayed with WD 40
Hi folks, Im an Aussie in Singapore
I have a smokinit 2 that I imported in and then purchased an Auber-ws dual probe.
I pulled out my smoking kit to get ready for this weekend, and my Auber seems to have gone off the planet??
I havent used my Smokinit 2 smoker in some months here in Singapore.
I pulled it out and setup with my Auber-WS just to check everything working.
I have power chor into Auber-WS and Smokingit power chord out of auber.
I have just entered one setting
C1 222
E 1 t
t1 15.9
The same settings I had as used before.
I have turned machine on, the temp is going WAY past 222
it is 0ver 400 and the alarms are showing AH1 and AH2
Can anyone please advise??
I have the auber unit hard installed into my smokinit #2
I live in Singapore and havent used my smoker for 6 months. I keep the auber in a zip lock bag stored inside. The permanent probe has some rust, I have cleaned and sprayed with WD 40
Hi folks, Im an Aussie in Singapore
I have a smokinit 2 that I imported in and then purchased an Auber-ws dual probe.
I pulled out my smoking kit to get ready for this weekend, and my Auber seems to have gone off the planet??
I havent used my Smokinit 2 smoker in some months here in Singapore.
I pulled it out and setup with my Auber-WS just to check everything working.
I have power chor into Auber-WS and Smokingit power chord out of auber.
I have just entered one setting
C1 222
E 1 t
t1 15.9
The same settings I had as used before.
I have turned machine on, the temp is going WAY past 222
it is 0ver 400 and the alarms are showing AH1 and AH2
Can anyone please advise??