boog1455
New member
Got my auber in this week. AT yesterday but with the factory program settings instead of the ones suggested in SI how to AT auber.... Stupid me right? I followed all the other instructions during the AT with bricks,etc. So after further reading last night on the forum I decided to re-AT today while I smked a couple of rib racks. Set up new programms as follows:
C1-170, E1-t, t1-1.0.....C2-235, E2-t, t2-5.5.....C3-140,E3-t, t3-2...
Then I set it to AT..... All was good for first hour but at hour 1.5 i notice temp was still at 170.... AT light is no longer blinking and she seems to be cruising at 170....I'm thinking it should have bumped over to C2 and ramped up to 235.... What AM I missing??? I checked program settings again and all is as i imput above. I checked program number and it still reads P-1...
C1-170, E1-t, t1-1.0.....C2-235, E2-t, t2-5.5.....C3-140,E3-t, t3-2...
Then I set it to AT..... All was good for first hour but at hour 1.5 i notice temp was still at 170.... AT light is no longer blinking and she seems to be cruising at 170....I'm thinking it should have bumped over to C2 and ramped up to 235.... What AM I missing??? I checked program settings again and all is as i imput above. I checked program number and it still reads P-1...