SuperDave New member Dec 6, 2016 #1 If the red light stays on 50 degrees past the set temp is that a calibration issue or a bad rheostat?
If the red light stays on 50 degrees past the set temp is that a calibration issue or a bad rheostat?
SuperDave New member Dec 7, 2016 #2 Played with it a little more this morning and power kicks back on pretty close to set point, -10, but just doesn't shut off when it is supposed to. Any thoughts would be much appreciated.
Played with it a little more this morning and power kicks back on pretty close to set point, -10, but just doesn't shut off when it is supposed to. Any thoughts would be much appreciated.
DivotMaker New member Dec 11, 2016 #3 Sounds like the rheostat may be going out, Dave. I'd contact Steve...should still be under warranty.
