Smokin-It User Forum!
General Discussions => Show Us Your Setup! => Topic started by: danorum on May 14, 2016, 04:02:02 PM
-
Thanks to some suggestions here, I decided to mount my #1 on a Craftsman 3 drawer cabinet. Here is the result.
Here is the bill of materials -
Craftsman Cart - http://www.sears.com/craftsman-26-in-wide-3-drawer-basic-ball/p-00931016000P (http://www.sears.com/craftsman-26-in-wide-3-drawer-basic-ball/p-00931016000P)
Cutting board top (I cut it to fit) - http://www.amazon.com/Stanton-Trading-2-Inch-Cutting-Board/dp/B0032AM0LW (http://www.amazon.com/Stanton-Trading-2-Inch-Cutting-Board/dp/B0032AM0LW)
McMaster-Carr fastners
M10-1.5 40mm stainless steel bolts - http://www.mcmaster.com/#catalog/122/3158/=12esmc6 (http://www.mcmaster.com/#catalog/122/3158/=12esmc6)
M10 oversized washers (30mm OD) - http://www.mcmaster.com/#catalog/122/3246/=12esmol (http://www.mcmaster.com/#catalog/122/3246/=12esmol)
Abrasion-Resistant Cushioning Washers 1/2" - 1.375" OD - http://www.mcmaster.com/#catalog/122/3257/=12esn42 (http://www.mcmaster.com/#catalog/122/3257/=12esn42)
Dan
-
Very nice.
-
I'm impressed, and a bit jealous.
-
I'm impressed, and a bit jealous.
Thank you. I did put all the parts, so you can have one too. :)
Dan
-
Good job, Dan! Looks great!